Montgomery Village Drywall Repair
(240) 896-4229Open 7 days, 7am–9pm
Fresh white skim coat covering the left part of a bedroom wall, with the older cream paint still showing on the right

Montgomery Village drywall repair that leaves no edge to find

Ceiling stains from the unit above, dents in a party wall, a hallway that has to look new before listing photos. Each patch is built flush, blended into the texture around it and checked under a low, raking light before the room is wiped down and handed back.

Which repair fits what you're looking at?

Most calls in the Village fall into one of four kinds of work. Each has its own page with the details: how the job runs, what it takes to make the repair disappear, and the questions owners ask most.

  • Ceiling leak repair

    Stains, soft spots and sagging board under a bathroom or the unit upstairs, cut out and replaced once the water has stopped.

    Ceiling leak repair, start to finish

  • Shared-wall patching

    Mount holes, anchor scars, dents and scuffs on the wall between you and the neighbors, patched flush with board of the same kind.

    How party-wall patches are handled

  • Patch and paint before a sale

    A room-by-room pass that clears picture-hanging holes, dings and corner cracks before listing photos and showings.

    The pre-listing patch-and-paint pass

  • Wall and ceiling crack repair

    Split seams, diagonal cracks off door corners and popped screws, opened up, re-taped and floated out flat.

    Fixing cracks and popped screws

What are these walls made of, and can a patch match them?

Nearly every wall and ceiling here is gypsum board: half-inch sheets on most walls, with heavier fire-rated board where code calls for it, such as a garage ceiling or the wall between attached homes. The board is the easy part. What makes a repair visible or invisible is the compound and the texture on top of it.

Compound

Deep fills and taped seams get a setting compound that hardens chemically and does not shrink back into a dip. The last thin coats are a softer topping mud that sands to a clean, feathered edge. Using one product for everything is the usual reason a patch shows a halo a month later.

Texture

Smooth walls are the hardest to fake, because a flat finish shows every ridge when sun crosses it at a low angle. Orange peel and knockdown can be sprayed and flattened to match. Many ceilings from the first decades of the Village still wear a sprayed popcorn texture, which is patched with a matching acoustic product rather than scraped off.

Matching

Before texture goes on the wall, it goes on a scrap of board held up in the room's own light. You look at it with us. If the bumps are too sharp or the spacing is off, the hopper is adjusted until the sample sits beside the old surface without a seam.

Why does a brand-new townhouse already have cracks?

Not every home here is from the late 1960s and 1970s. Construction on Bloom Village, the 494-lot neighborhood of townhomes and single-family houses on the old Montgomery Village Golf Course, began in June 2020, and new owners there sometimes call about marks that look alarming on a wall that is only a year or two old.

Most of it is the framing settling in. Studs and joists dry out after the house is closed up, and as the wood shrinks a little it lets go of drywall screws, which push a small round bump through the paint. Hairline cracks show up at the top corners of doors and windows, where the board is under the most strain. Upstairs, roof trusses can lift slightly in winter and pull the ceiling away from the top of an interior wall, leaving a crack along the corner that seems to close again by summer.

None of this means the house is failing. It does mean the fix should wait until the first full year of seasons has passed, and that a popped screw needs a new screw beside it, not just a dab of compound over the head. If the builder's paperwork still covers drywall touch-ups, read it before you book anyone, including us.

What should you photograph after a leak or a dent?

When water comes through a ceiling, the first hour is about stopping it. The next hour is about making a record that an insurer, a landlord or a condominium board can follow later without guessing. We don't advise on claims or say what a policy covers. We just know which pictures people wish they had taken.

  • A wide shot first. Stand in the doorway and photograph the whole room, so the stain is shown in place, with the furniture under it.
  • Close-ups with a scale. Hold a tape measure or a ruler next to the stain, the crack or the hole. A close-up without a scale can be read as any size.
  • The outline, dated. Trace the edge of a ceiling stain lightly in pencil and write the date beside it. If it grows overnight, you will know, and so will anyone you show it to.
  • The source. If the water came from an overflowing tub, a failed supply line or a unit above, photograph that too, and write down who you told and when.
  • Anything you threw away. Wet insulation, a soaked rug or ruined boxes: photograph them before they go out to the curb.

When the repair is done we can give you a short written note of what was cut out, what was replaced and what was primed and painted, which fits neatly into the same folder.

Patch it, replace the sheet, or skim the whole wall?

Three approaches cover almost every wall we see. The right one depends on how deep the damage goes and how much of the surface it touches, not on which is quickest to sell.

Spot patchNew section of boardSkim coat over the wall
Best forHoles, dents and cracks smaller than a handSoaked, crumbling or sagging boardA wall with many small flaws or torn paper
VisitsUsually two short onesTwo or threeTwo to four
DustLightModerateLight
Fixes board that got wetNoYesNo
Evens out a whole surfaceNoNoYes
Paint afterwardThe whole wallThe whole wall or ceilingThe whole wall

The drawing below shows the same comparison at a glance: a full dot where an option does the job well, a half dot where it can work with limits, and an empty ring where it is the wrong tool.

Small holesand cracksWet or softboardMany smallflawsLowdustShort timein the roomSpot patchNew sectionSkim coat
Full dot: does the job well. Half dot: works with limits. Ring: the wrong tool.

How will my floors and furniture stay clean?

Drywall dust is fine enough to drift down a hallway and settle on a bookshelf two rooms away, so the protection goes up before a single cut is made. In a garden condo or a narrow townhouse stairwell, that starts at the front door.

  • Runners from the entry to the work area, taped at the edges so nobody trips on a curl of paper.
  • A plastic wall with a zipper door across the doorway of the room being worked on.
  • Supply registers and return grilles covered, and the air handler switched off while sanding, so dust stays out of the ducts.
  • Furniture moved to the middle of the room and wrapped, or carried out if there is space.
  • Sanding done with a sander hooked to a filtered vacuum wherever the surface allows it.

At the end of each day the floor is vacuumed, the plastic is checked, and the baseboards and window sills under the repair get wiped with a damp cloth. You should be able to run a finger along the trim and come away clean.

Can you turn over a rental unit between tenants?

The Village has four apartment rental complexes and plenty of individually rented townhouses and condos, so turnover work comes up often. The aim is a unit that is patched, primed and waiting for the painter before the next lease starts.

Owners and property managers usually send a move-out list or a set of photos, and we group the work so one visit covers every room that needs it: anchor holes, door-handle dents, a stained bathroom ceiling, the scuffs along a stairwell. Several units in the same building or court can be lined up back to back.

Access can run through a lockbox or a manager's key. If tenants are still living there, we work from the times you have already given them notice for, keep the work area closed off, and leave the rest of the home as it was found. A dated photo of each finished repair goes back to you for the file.

Will the patch show through the paint?

It will if the paint goes straight onto bare compound. Fresh mud soaks up paint differently from the wall around it, so the patch dries flatter or shinier than its surroundings. That shift in sheen is called flashing, and it is the reason a well-built patch can still be spotted from across a room when the light hits it sideways.

Every patch here gets a coat of primer first, and stain-blocking primer wherever water has been. After that, the finish coat goes on the whole wall, corner to corner, or the whole ceiling, because touching up a single square almost never blends. Eggshell and satin are the least forgiving sheens. Flat ceiling paint hides the most.

We can prime and paint, or prime only and leave the finish to your own painter. If you still have the leftover can, the color code on its lid saves a trip to the store. If not, a small chip cut from behind a switch plate can be matched.

Do you come out to my part of town?

Montgomery Village
Every neighborhood, from the first streets of Goshenside to Stedwick, Whetstone, Lakeside and the Bloom Village townhomes.
Gaithersburg
The city next door, along I-270 on the Village's western side.
Germantown
Townhouse courts and newer subdivisions up the I-270 corridor.
Derwood
Homes north of Rockville and close to the Shady Grove Metro.
Washington Grove
The small town on the far side of Gaithersburg with its old camp-meeting cottages.
Laytonsville
Larger lots and older houses in the countryside to the north.
Clarksburg
Newer neighborhoods at the top of the I-270 corridor.
Olney
Houses and townhomes east of Gaithersburg.
Rockville
The county seat, for condos and older homes alike.

Street-level detail for each place is on the page listing every town and neighborhood we cover.

What does the weather here do to walls and ceilings?

This part of Montgomery County has a humid subtropical climate, much like Washington, D.C. That means sticky summers, real freezes in winter and a lot of movement in between, and each season leaves its own marks indoors.

Summer humidity

Air conditioners work hard, and a clogged condensate line or a sweating duct in the attic drips onto the ceiling below. The stain is usually round and sits near a vent or the air handler closet.

Storms

Hard summer rain finds gaps around windows and roof flashing. Look for brown streaks under a window corner or a stain on a top-floor ceiling near an outside wall.

Winter cold

A water line in an outside wall can freeze and split. The damage often shows only after the thaw, as a wet, bulging patch low on the wall.

Spring and fall movement

Dry winter heat and damp summer air make framing shrink and swell, which opens seams and corner cracks that seem to come and go.

What about the garage wall or a finished lower level?

The wall between an attached garage and the house, and a garage ceiling with a bedroom above it, are built with fire-rated board for a reason. A hole there from a car door, a bike handlebar or a removed shelf bracket gets patched with board of the same fire resistance and taped solid, never covered over with a scrap of thinner sheet.

Finished lower levels have their own problem: water arrives from below as well as above. Before any repair, the wall is checked with a moisture meter, and if the reading is high we wait. Closing up damp board traps the water behind fresh paint, where it turns into a musty smell and a second repair. Board near the slab is replaced with a moisture-resistant type and held a little off the floor so it doesn't wick.

Want us to come out and see it?

Tell us what you are seeing, or send a photo by text with the room and the size of the damage. You will hear back with what the repair involves and when it can be scheduled.

Open 7 days, 7am–9pm